| |
RC1-0933-000CN
Belt pulley - Small pulley opposite paper feed shaft for paper feed belt (three used)
|
RG1-4131-000CN
Carriage pulley assembly - Drive belt tension pulley assembly
|
RC1-9620-000CN
Flange pulley - Attaches to the paper feed cogged belt located on the intermediate feed main body assembly
|
RB3-0067-000CN
Pulley roller (accommodates one feed belt) - Small black roller approximately 1.59cm (5/8 inch) long with one ball type pulley
|
RB3-0061-000CN
Pulley roller (accommodates three feed belts) - Small black roller approximately 3.49cm (1-3/4 inches) long with three ball type pulleys
|
RB1-6195-000CN
Paper feed pulley - 2 Idler pulley for small belts included.
|
Q7829-60151
Pulley assembly - For transmission timing belt
|
Q6665-60045
Carrier tension pulley - Carrier belt idler pulley
|
|
|
|
|
FS5-3577-000CN
39-tooth pulley - Runs on the woodruff roller - Located next to the roller flag
|
FB2-8465-000CN
Lifting cable pulley - One attached on each side of lifter wire shaft
|
|
|
CA02542-0146FJ
Exit motor pulley - Mounted on exit motor shaft - Drives exit belt - Part of high capacity output (HCO) assembly
|
C4704-60020
Idler pulley - For carriage (Y-axis) belt - On right end of plotter
|
C3195-60169
Idler pulley - Applies tension to the left end of the carriage belt
|
C3190-60132
Idler pulley - For main drive belt - On left end of plotter - Includes pulley, shaft and spacer
|
C3170-60009
Reduction pulley - Includes 2 Bearings, Shaft (0.16in Diameter on Both Ends), Flange, Pulley and Instructions
|
C2642-60220
'Turn around' pulley assembly - Includes idler pulley and housing - Provides carriage belt tension
|
C2114-40052
Idler pulley with bearing - Mounts on idler shaft
|
53020065KT
Elevator pulley - Part of output stacker - Drives worm gear in elevator gear assembly
|
07570-60112
Idler drive pulley - Applies tension to the pen carriage drive belt (small belt)
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|