|
07BA12414KC
Support bracket for rear feed unit (large) - Located on the lower rear cover
|
|
C7769-60409
Bracket kit - Includes the left cutter guide bracket and left encoder holder
|
C1633-40038
Left bail bracket for Hewlett Packard Designjet Plotters.
|
Q1247-60187
Service automatic rollfeed (ARSS) bracket - Large bracket that the ARSS cleanout service kit attaches to, located at the back of the plotter. ( Entire kit Q1247A).
|
C2165-00001
Left bracket - Carriage rod adjustment bracket (Left)
|
RA0-1186-000CN
Right side fuser bracket (L-shaped) - Provides mounting support for the fusing assembly
|
|
C3180-40013
Bracket for bail switch assembly - Installed to the right side plate of the plotter
|
|
|
Q6712-69001
Foot assembly - Includes one foot and one support tube.
|
|
|
RA0-1185-000CN
Left side fuser bracket (L-shaped) - Provides mounting support for the fusing assembly
|
|
RB2-5008-000CN
Cartridge memory antenna mounting bracket (support plate)
|
|
07575-40125
Drive-tensioner bracket for pen carriage drive belt tensioning wedge
|
CH539-69001
Foot Svs Black 2 pcs Foot Assembly SV Foot assembly (Black) - Includes two feet
|
C4713-40017
Right encoder bracket - Holds right end of encoder strip
|
C7769-60391
Service station bracket - Installed on right-side of service station
|
|
07BA12441KC
Support bracket for rear feed unit (small) - Located on the lower rear cover
|
|
CC431-00002
Formatter bracket - For fax/memory card models only
|
Q1273-60112
Rear tube brackets (two used) - Used to connect the ink supply tubes to the chassis
|
Q1273-60229
Left bracket assembly - Connects the ink supply station to the printmech
|
C6426-00003
IEC connector bracket - Holds the power cord socket
|
|
|
|
C7769-60156
Service station bracket - Installed on right-side of service station
|
C2170-00008
Right bracket - Carriage rod adjustment bracket (Right)
|
C4562-40032
Belt tension bracket - Pivot bracket for idler pulley - Applies tension to the carriage belt
|
|